ATV-Guru Rincon skid plate plans
I do not to build skid plates to sell!
Email me at admin@ATV-Guru.com for the measurements
and schematic if you would like to build your own.
Skid plate is made of 1/4" hard 6061 aluminum with counter bored holes on bottom.
This is a copy of the one I am running on my Rincon.
It was cut out with a plasma cutter.
 |
Front spacers |
 |
Middle spacers |
|
|
Rear block
spacer
|
 |
All holes except rear are counter-
bored |
 |
Rear holes
no counter bore |
 |
The front bend. |
Email me at admin@ATV-Guru.com for the measurements
and schematic if you would like to build your own.
Want more Rincon project tips and ATV-Guru products?
Visit my homepage and check out ATV-Guru Manufacturing's Rincon, Polaris, and Suzuki
bumpers and hitches!
Also check out the Rincon Tech tips section!
